Ceramics and glasses · Workhorse

Ferrites and lossy ceramics

Fe3O4values describe: NiZn ferrite

Big science (accelerators, light sources, public fusion)

Why it wins

Inside cavities and kickers, unwanted RF must die somewhere: HOM absorber ferrites and lossy dielectrics turn beam-induced modes into heat on purpose.

Why not the alternative

Unloaded cavities ring; external loads cannot reach trapped modes.

Watch out

Outgassing and brazability of ferrites are their own qualification campaigns.

Properties

The values below are candidate: compiled from the sources named, not yet individually validated. Provisional provenance: CERN Accelerator School, vacuum and materials proceedings.

Wet cleaning

Recipesolvent wipe, dry; porous grades bake rather than wash
Forbiddenaqueous soak: porosity holds water; and check for zinc before any hot service
Limitthe Curie point sets the bake, and the bake sets the cleaning that is possible

Vacuum and outgassing

Outgassing, unbaked (10 h)5×10⁻⁹ mbar·L/s/cm²
Outgassing, baked5×10⁻¹² mbar·L/s/cm²
Vapour pressurezinc-bearing ferrites are a vapour risk hot: check the composition

Temperature

Bake, assembled200 °C
Vacuum degas400 °C
Metallurgical limitCurie 100–400 °C by grade; above it the damping is gone

Thermal

CTE8–10 ppm/K
Thermal conductivity3–6 W/m·K
Specific heat750 J/kg·K
Emissivity0.9
Melting / softening1400 dec. °C

Mechanical

Strength50–100 flex MPa
Elongationnil
Young's modulus150 GPa
Hardness600 HV
Density4.8–5.2 g/cm3

Electrical and magnetic

Relative permeabilitythe whole point: 100–2000 initial
Resistivity1×10⁵–1×10⁸ Ω·cm

Engineering

Corrosiongood
Joiningclamped or bonded
Process notesdamps HOM and parasitic modes in RF structures
Availability and costRF component suppliers

Grades

CMD5005 class ferritekicker and absorber heritage grade
TT2-111R classSRF HOM absorber ferrite
AlN-SiC lossy ceramicsbrazable absorbers where ferrites fail
Sources · 1
  1. CERN Accelerator School, RF systems

← Materials